Unex Manufacturing, inc.
Unex Manufacturing, Inc.
"The Track to Better Picking"est 1964
Span-Track Carton Flow Track
Spant-Track Carton Flow Track

Span-Track® Guide and Accessories


Replacement Rollers
Add to existing product or replace damaged rollers. Standard or spring loaded tempered aluminum rollers, 3/4" diameter with full-length 3/16" steel axle.

StandardStandard Roller
Spring Loaded
Spring Loaded Roller
Replacement Labels
Include with hangers. 1-1/2" tall, width to fit track ordered. Designed for two sided use, insert into built-in label holder of front and rear of track.

Span-Track Unex Manufacturing 800-334-UNEX
     
Span-Track Unex Manufacturing 800-334-UNEX
Infeed Guides
For stocking from the rear. Aligns carton into proper position on track

Infeed Guides
End Caps
End caps included with hangers. Add to each side of the label holder on hanger as shown

End Caps
Slow Down Plate
Galvanized steel. Simply snaps over rollers. Designed for two functions:
  1. As an impact plate at the load end to absorb impact.
  2. As a slow down plate placed anywhere along the track length.
 Slow Down Plate
High Profile Rigid Splice: For Long Runs

Two High Profile Span-Track® sections can be joined track-to-track for "extra deep" carton flow. An intermediate beam must support the splice. Capacity, flow and full use of vertical space are maintained over the full length of the extended run, from load point to pick point.
High Profile Rigid Splice
Low Profile Bridge Splice: For Long Runs

Two special "notches-end" Low Profile Span-Track® sections can be joined track-to-track for "extra deep" carton flow. With an intermediate beam supporting the splice, capacity, flow, and full use of vertical space are maintained from load point to pick point.
Low Profile Rigid Splice

Adding Rollers to Create Impact Zone

Rollers can be added to the ends of 2" and 3" o.c. track sections to create a roller spacing of 1" o.c. for a 12" or 18" long portion of the track end. This results in an "Impact Zone" which absorbs the impact of loading and assists carton flow.

To Price: Price standard Span-Track® then ADD the price of the Impact Zone you want (12" or 18" long) based on track width of standard section.

IMPORTANT:Indicate which track end gets the Impact Zone - Front or Back.

Track Width: Span-Track provides excellent product tracking - no guide rails are needed. Cartons with firm flat bottoms may be wider than track section.

Pitch: Required pitch varies with carton quality and weight. 1" per foot is recommended. Test flow with actual product at installation.

Roller Centers: Cartons with firm flat bottoms will flow properly if supported by at least four rollers. Poor bottoms or heavier weights may require closer roller spacing for proper flow.
 Adding Rollers to Create Impact Zone